Welcome to the Workshop 12 family. 🤘
Below is your step-by-step installation guide, designed to walk you through everything from wiring and setup to troubleshooting. Please follow each step carefully. If you run into an issue that isn't covered here, scroll to the bottom of the page to reach out via email, phone, or by booking a 1-on-1 video call.
STEP 1: Wiring Walkthrough
This blog explains how to install your Chrysler 200 ultra-wide screen.
What's in the box
- 10-inch display unit with rear connectors.
- Main stereo harness with integrated DSP and CAN bus.
- RCA outputs for subwoofer and audio.
- Reverse camera connector.
- SIM card tray for LTE.
- FM/AM antenna.
- OEM USB connector adapter.
- LTE and GPS antennas.
- Installation tools.
Before You Begin — Tools & Preparation
- basic tools plastic pry tools, a screwdriver set, and optionally a socket (commonly 10 mm) or hex key.
- Disconnect the vehicle’s negative battery terminal to prevent electrical faults or airbag warning lights.
- Confirm that your kit includes the correct vehicle-specific plug-and-play wiring harness, antennas, and all included accessories.
Step 1: Remove the Factory Infotainment Screen
- Use plastic trim tools to gently pry off the dashboard trim surrounding the factory screen.
- Remove the mounting screws securing the OEM infotainment unit.
- Carefully pull the factory screen forward.
- Disconnect all factory wiring connectors and antenna plugs from the rear of the unit.
Step 2: Connect the Plug-and-Play Harness
Take the Workshop 12 plug-and-play wiring harness and connect it directly to the vehicle’s OEM connector that was removed from the factory screen.
Connect all required accessories from the kit, including:
-
GPS antenna
-
LTE/4G antennas (if included)
-
External microphone harness
Ensure all connectors are fully seated and secure.
Step 3: Mount the New Screen
After removing the factory screen, transfer any required mounting brackets or hardware to the Workshop 12 screen as needed.
Align the new ultra-wide screen into the dash opening.
Secure the screen using the factory mounting points or provided screws.
Reinstall the dash trim panel, pressing evenly to ensure all clips are properly seated without applying excessive force.
How To Change Your Theme
How To Fix Your Reverse Camera
How To Adjust Your Mic Gain
Ultrawide Screen Software Walkthrough
Additional Resources for Below:
- Touch Button Calibration
- How to use Splitscreen
- How to press the RST Button
- Apple CarPlay Walkthrough
-
Connecting ELM OBD
- Radio Booster Installation
Need Extra Help? Book a 1-on-1 video call.
If you have an issue that hasn't been covered, or if you just prefer a guiding hand, you can schedule a live troubleshooting and setup session with a Workshop 12 technician.
Book your 1-on-1 Video Call by clicking this link 👉 BOOK NOW
Don't see a time that works?
Simply email us at info@workshoptwelve.com with two preferred dates and times, and we’ll do our absolute best to accommodate your schedule.
Contact us: