Welcome to the Workshop 12 family. 🤘
Below is your step-by-step installation guide, designed to walk you through everything from wiring and setup to troubleshooting. Please follow each step carefully. If you run into an issue that isn't covered here, scroll to the bottom of the page to reach out via email, phone, or by booking a 1-on-1 video call.
STEP 1: Wiring Walkthrough
What's in the box:
- SIM Card Tray
- LTE Antennas
- GPS Antenna
- RCA Camera Connections
- RCA Audio Connections
- 2 Female USB Ports
- USB Connection for Reverse Camera Feed
- Main stereo harness
- Microphone
- BUZZER (This BUZZER does not require installation.) Backup camera trigger wire)
Wiring Diagram
STEP 2: Installation
Before You Begin
-
Tools needed: basic screwdrivers, trim removal tools, and possibly a socket set.
-
Work on a flat surface with good lighting.
-
Keep your factory parts and hardware organized (dash trim, screws).
Remove Factory Center Screen
1. Pry off the grill at the top of the dash and unscrew 2 7mm screws.
2. Pry off the dash trim gently using the included trim removal tool.
3. Unscrew and remove the factory screen assembly.
4. Disconnect connectors: main harness, USB/AUX, antenna, camera, and climate harness.
Install Workshop 12 Screen
-
Connect the plug-and-play harness to the vehicle’s factory connectors.
-
Match connectors: power, speakers, camera feed, climate, USB, CAN/Bus.
-
-
Install the CAN/bus module in line with the wiring harness.
-
Attach antennas (LTE and GPS) in recommended dash locations.
-
Secure the new screen into the dash opening; it should fit flush without force.
-
Reinstall trim pieces, ensuring all clips and edges are seated properly.
Connect and Test Before Finalizing
-
Confirm the following before fully tightening panels:
-
Screen powers up and displays correctly
-
Climate controls work (if integrated)
-
Reverse camera feed displays when in reverse
-
Steering wheel controls respond
-
Wireless CarPlay/Android Auto pairs with phone
-
-
If any feature doesn’t work, double-check harness connections.
-
Secure all screws and panels once testing is complete.
-
Route cables cleanly behind the dashboard.
-
Tuck unused wires safely to avoid rattles.
-
Enjoy the new screen and functionality.
-
Step 3: Complete Software Walkthrough
Additional Resources for Below:
- How to change the time on your unit
- Sim-card tray
- How to Keep Apple CarPlay from Popping Up
- How to press the RST Button
- Apple CarPlay Walkthrough
-
Connecting ELM OBD
- Radio Booster Installation
Need Extra Help? Book a 1-on-1 video call.
If you have an issue that hasn't been covered, or if you just prefer a guiding hand, you can schedule a live troubleshooting and setup session with a Workshop 12 technician.
Book your 1-on-1 Video Call by clicking this link 👉 BOOK NOW
Don't see a time that works?
Simply email us at info@workshoptwelve.com with two preferred dates and times, and we’ll do our absolute best to accommodate your schedule.
Contact us: